Define the length of the closure line.Enter P to re-enter point mode, and then enter the points to define the closure direction.To place elements using Bearing and Distance (There is 3 methods): Method 1: Use Place Line tool 1. For this example, enter 2 for the first distance point, and 1 for the second distance point to draw the first segment. Mode: Bearing Note: Save settings to keep this for future sessions of this file. Enter the point numbers to define the distance.For this example, enter 2 for the first direction point, and 3 for the second direction point. The transparent command 'PN is still activated, so you can enter the point numbers to define the direction.Stack Exchange Network Stack Exchange network consists of 182 Q&A communities including Stack Overflow, the largest, most trusted online community for developers to learn, share their knowledge, and build their careers. At the command line, enter P to use the screen selection mode. I want to use these waypoints, that I have now in Shapefile format, to draw line shapefiles that.Enter the point number at the command line prompt.Double-click Line by Direction and Distance. In the Toolspace, on the Toolbox tab, expand Miscellaneous Utilities Coordinate Geometry. At the command line, enter 'PN to use the point number transparent command. The following example shows how you can use the Line By Direction and Distance command to draw a line from the endpoint of a previously drawn line, at a bearing of N 18 02' E, at a distance of 11.0 feet.In the Toolspace, on the Toolbox tab, expand Miscellaneous Utilities Coordinate Geometry.The following example shows how you can use the Line By Direction and Distance command to draw a line from point 5, parallel to line 2-3, with a distance equivalent to 2-1, and then a closing line parallel to 1-2 and closing on line 2-3. This is the angle from north clockwise to B. For example, the bearing from A to B is 100. Measure the clockwise angle between the north line and this line. Draw a line connecting the start location to the end location. Upgraded to 2014 and trying to get things set for drawing property boundaries. Everything enters but when I enter the last command of the bearing and hit enter it stays in the red boxed outline and does nothing. This is useful when you want to draw a line using the direction from a pair of points and you want the distance to equal the distance from a pair of points. Start by drawing a vertical line representing north at the first location. I keep trying to draw a line by bearing and distance using the format 50.00'
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |